Room Configuration for Aim Line Tutorial

Room Configuration for Aim Line Tutorial

The following will walk you through the steps to set your room configuration for FSX 2020.



On your computer you are going to open the File Folder

 

Then select "This PC" along the left side of the screen. Once opened select "Windows (C:)


 




















Next select the folder Program Files (x86), then Foresight Experience Components










Inside this folder you should see the "Room Config Tool".  Run this program and you will be able to input the measurements of your simulator setup to properly set the aim line on the screen.


    • Related Articles

    • Accessing The Room Configuration Tool - Adjusting Target Line In Software

      In order to adjust the target line (aim line or center line) within your software you must access the Room Configuration Tool. This is a application, separate from the Simulation Software. To do this please see the steps below: 1. Open your WINDOWS ...

    • Target Alignment via Alignment Stick

      Using the Alignment Stick To setup the device to use the alignment stick you will need to go to your LCD Menu on the device by pressing the OK button. Once you have opened the menu, navigate down to the Target Alignment option and press the OK button ...

    • Target Alignment via Alignment Stick

      Using the Alignment Stick To setup the device to use the alignment stick you will need to go to your LCD Menu on the device by pressing the OK button.  Once you have opened the menu, navigate down to the Target Alignment option and press the OK ...

    • Zombie Golf Tutorial - Where to Locate

      In regards to the Zombie Golf Tutorial, it’s just a slide show of some picture files. These should be located within your Zombie Golf system files (C:\Program Files (x86)\ZombieGolf\System\Tutorial)… Another way to find them is you can right click on ...

    • Adjusting The Center Hitting Line

      To proceed, locate a 20 foot tape measure and proceed with the following: 1. With your software closed, locate the search box in the bottom left hand corner of your Windows Desktop. 2. Type the word "roomconfig" into the search box. If this is not ...