Keeping your device’s firmware current ensures optimal performance, compatibility, and access to the latest features.
This guide explains how to update firmware for GC3, Launch Pro, and LPi devices.

Note: Each device type has its own update process.
Choose the correct section for your model below.

GC3 and Launch Pro - Update Through Local Network (Internet Required)

1. Power On the Device
   Ensure your GC3 or Launch Pro is powered on and connected to power.

2. Connect to Network
   Connect the device to your local network via one of the following:

   • Ethernet cable directly to your router, or

   • Wi-Fi (Settings → Network → Wi-Fi)

   The network must have active internet access.

3. Access Firmware Menu
   On the device, navigate to:
   Quick Launch Menu → Settings → Firmware

4. Check for Updates
   Tap Check for Updates.
   If an update is available, you’ll see an upgrade prompt.

5. Download and Install
   Select Download and Upgrade to start the process.
   The device will automatically download, install, and restart.

6. Verify Firmware Version
   After reboot, go back to Settings → Firmware to confirm the version number matches the latest release.

LPi - Update via Firmware Upgrader Tool (Internet Required)

1. Download the Upgrader Tool
   On your PC, download the LPi Firmware Upgrader Tool (.exe) from the LPi Support Page.

2. Connect the LPi to the Local Network

   • Connect the LPi to your router or network switch using an Ethernet cable.

   • Ensure your PC is on the same local network as the LPi.

   • The upgrader tool requires this connection to detect the device.

3. Run the Upgrader Tool
   Launch the downloaded upgrader application on your PC.
   The tool will automatically search for LPi devices connected to the network.

4. Select Device and Install Update
   Once your LPi appears in the tool, select it and follow the on-screen prompts to begin the firmware update.

5. Wait for Installation to Complete
   The LPi will install the firmware and restart automatically.
   Do not disconnect power or network during the process.

6. Verify Firmware Version
   Reopen the upgrader tool or check the LPi display to confirm the firmware version updated successfully.

Quick Troubleshooting

• Device not detected: Ensure both PC and device are on the same network and connected via Ethernet.

• Update fails or stalls: Restart the device and tool, then try again.

• LPi not found by tool: Temporarily disable firewall or VPN software that may block local connections.

FAQs

Q: Can I update LPi over Wi-Fi?
A: No. LPi firmware updates require a wired Ethernet connection.

Q: Do GC3 and Launch Pro updates require a PC?
A: No. GC3 and Launch Pro devices update directly through their onboard menus using an internet connection.

Q: Will updating affect my stored data or settings?
A: No. All user settings and club/bag data remain unchanged.

Reference

For the official support pages and visual instructions, visit:

• GC3/Launch Pro Firmware Update Guide

• LPi Support Page