Determining when the GC2 Flash Module Requires Replacement
Flash Modules are items that require occasional replacement. You may need to replace the flash device on your GC2 if your device is not recognizing shots (displaying dashes) or displaying inconsistent readings.
1. Remove device from any protective enclosure and place on a level floor with the foot/latch properly set to assure correct operation.
2. Before attempting to diagnose the flash module, confirm that your device has not been subjected to static shock by holding down the power button for 6 seconds (until the device powers off) and restarting the device again.
3. Place the GC2 on the same level hitting surface as the ball. Confirm that the device recognizes the ball when placed in the hitting zone (as indicated by a solid green light). Proceed with hitting the ball. > If the device displays DASHED READINGS, the device is working but the flash needs to be replaced. Please replace the flash as instructed in the GC2 Unser Manual.
> If the device DOES NOT RECOGNIZE BALL, consult the section titled “GC2 Device not recognizing the ball/inconstant reading”.
4. If after consulting both of these troubleshooting steps the GC2 still does not respond to shots, please contact Foresight Sports technical support.
Related Articles
GC2 Device Flash Module Operation Occuring Very Fast
If you are seeing that your device is operating in a state where the Flash Module is firing more quickly than you expected this may be due to the type of shot being taken. The device will adjust home many flashes is required to accurately take the ...
GC Product Network Trouble Shooting
This guide is to assist with trouble shooting network issues from a device stand point. The network is required for the following: Subscriptions Device Registration Device Validation Purchased Feature Add-ons Region Confirmations Should you have an ...
GC Hawk Security Key
The GC Hawk uses a security key instead of a password. The security key is 'FSSPORTS'.
GC Quad Pin Code
The GC Quad uses a pin code instead of a password. The pin code is 'FSSPORTS'.
If the GC2 Device Does Not Recognize the Ball
Power off the GC2 device. If connected to a computer, disconnect the USB cord. Wait 5-10 seconds before powering device on again. Do NOT plug the USB cable into the GC2 at this time. Place a ball in the left or right hitting zone If the device ...