Changing the GC2 On-Screen Units of Measurement
- Once the GC2 device has fully powered on, select the left most arrow button on the front LCD panel.
- To select an option, navigate with the UP and DOWN arrow keys. To select the desired unit of measure, press the "OK" button until the setting appears.
- With the desired unit of measure selected, press the left most arrow key again to return to the ball-find/play mode.
- Your new settings have been saved and will now be displayed during play.
Related Articles
If On-Screen Image is not Filling the Entire Screen
The projected image may not fill your screen if the resolution is set incorrectly. To correct this: Right-click on the desktop and find “Screen resolution”. Select the projector from the options offered and change the resolution. NOTE: Make sure that ...
If On-Screen Image is Inverted
Because all projectors are designed to be mounted to a ceiling (inverted) or placed on a level surface, they have a built-in function that allows the image to be flipped to accommodate either orientation. To correct a flipped image: Go to your ...
Ball Flight From Bottom of Screen - White Flashon Screen
The Twitch/Flash is from the camera looking down at the ball during the initial flight. You can see how the ball starts from the bottom of the screen rather than from the point of impact, causing this issue for you. Check the room config. You can ...
If a Blank Screen is Displayed During Game Start-Up
Confirm that the computer is properly connected to the monitor and/or projector. Foresight Sports recommends using the same connection-type (such as DVI) if connecting to two monitors or a projector. Once you've confirmed that the monitor and/or ...
GC Product Network Trouble Shooting
This guide is to assist with trouble shooting network issues from a device stand point. The network is required for the following: Subscriptions Device Registration Device Validation Purchased Feature Add-ons Region Confirmations Should you have an ...